Support Center

Main Menu

Internet Access Numbers

Enter the phone number where you are connecting to the internet.

Knowledge Base

New Search

Hide Graphics

Article ID: 375840
Last modified date: Tue Dec 18 13:55 2007

This article provides steps for setting up and configuring a PPPoE connection in Mac OS X 10.5.

Introduction

Ethernet PPPoE is configured within the Ethernet Network Panel in Mac OS X 10.5. This articles illustrates how to setup and configure an EarthLink DSL PPPoE connection.

Important: The modem should be set in Bridge Mode before connecting with PPPoE. This configuration does not require a router if directly connected to the modem.

Setup and Configuration of a Ethernet (PPPoE) Connection

Click the Apple Menu and choose System Preferences.
Under the Internet and Network section, choose Network.
On the left menu, select Built-in Ethernet.
From the drop-down menu next to Configure, choose Create PPPoE Service.
Enter a name to identify the PPPoE Connection.
Enter the Username and Password. Click the Apply and then click Connect.

Important: Remember to place a check mark in the box next to Show PPPoE Status in menu bar.

A new configuration for PPPoE appears in the Network Panel.

Related Articles:

Configuring Your DSL Modem for Bridge Mode

Was this article helpful to you?
Yes No
If any information was unclear, or the information you were seeking was not provided, please let us know! Your feedback will help us improve this service.

NOTE: Comments entered here will NOT receive a personal email response. If you need an EarthLink representative to respond to your issue, please click here to initiate a Chat session.